Cold pressure in the boiler (Is there a boiler pressure gauge?) from overfilling or otherwise. A faulty power board, either thinking there is no water available or not closing a relay properly. (If applicable) A lack of adequate flow from the reservoir triggering the powerboard to notice the lack of water. Water without enough mineral content(Appearing as lack of available water). (Unlikely if not recurring)
Instead of shutting it off and on, when not heating, open the steam valve for 5 seconds... Does that get it heating? If so, you've released the cold pressure and discovered at least one of the problems.
Interesting ideas... Here is what I was able to test based on your input
Cold pressure- I have two gauges. There is a "high" one that reads to about 16 bar and a "low" one that reads to about 3 bAr. This morning the upper one was reading 9 bar with the machine cold. The lower gauge was at 0. I turned the machine on and it clicked several times as if to try to turn on the heater - the red light flashed with the clicks. Then the pump came on. I let it run for a out ten seconds but then shut the machine off because I was afraid the pump would over fill the boiler again and the interior of the machine would get sprayed and flooded - (it's happened several times)
I then turned the machine on again, I got the clicks again and with the upper gauge still reading 9bar I opened the steam and hot water taps. Nothing happened. No steam or water came out, the pressure didn't change, the pump didn't come on.
I then turned it off then on again and got more clicks and finally the heater turned on consistently and cycled at its proper pace - now that the new p-stat is installed the machine cycles at the right cadence but the machine either continues to overfill and/or the heater doesn't go on when I first turn the machine
Mineral content of the water- I have t tested this yet but was going to buy a bottle of crystal geyser water to see if that made a difference.
Someone else asked if the main power switch was "lazy". Not sure how you would diagnose that. However the switch is brand new as I just had a three way switch installed.
Symbols: = New Posts since your last visit = No New Posts since last visit = Newest post
Forum Rules: No profanity, illegal acts or personal attacks will be tolerated in these discussion boards. No commercial posting of any nature will be tolerated; only private sales by private individuals, in the "Buy and Sell" forum. No cross posting allowed - do not post your topic to more than one forum, nor repost a topic to the same forum. Who Can Read The Forum? Anyone can read posts in these discussion boards. Who Can Post New Topics? Any registered CoffeeGeek member can post new topics. Who Can Post Replies? Any registered CoffeeGeek member can post replies. Can Photos be posted? Anyone can post photos in their new topics or replies. Who can change or delete posts? Any CoffeeGeek member can edit their own posts. Only moderators can delete posts. Probationary Period: If you are a new signup for CoffeeGeek, you cannot promote, endorse, criticise or otherwise post an unsolicited endorsement for any company, product or service in your first five postings.