bobby120 Senior Member Joined: 2 Jun 2013 Posts: 1 Location: berkeley Expertise: Just starting
Posted Sun Jun 2, 2013, 2:22pm Subject: la pavoni europiccola EPBB-8
i don't know where to post this. i am trying to fix my la pavoni by myself. the wiring is fine, everything is fine... its just that when I pull the lever up, i do not pull any water. i haven't changed the way i fill or tamp my coffee. i believe i may have caused this problem by packing too tight and forcing the lever down. i've been doing this repeatedly over a few years. This is not an issue of just packing and tamping looser. I believe that i've blown the gaskets in the pulling body. i have learned by my mistake and learn how to properly fill and tamp. is there hope for me?
please redirect/let me know where to post this note.
Posted Sun Jun 2, 2013, 3:22pm Subject: Re: la pavoni europiccola EPBB-8
Welcome to coffeeGeek! Actually this should have been posted under "Lever Machines" possibly a mod will be kind enough to move it for you. Sounds like you've blown a seal. The La Pavonis are actually fairly simple to work on. You can get info, as well as order parts, from at least a couple of well known sources-
SStones Senior Member Joined: 24 Nov 2012 Posts: 362 Location: Canada Expertise: Professional
Espresso: Giga 5, ECM Giotto, Rocket... Grinder: Anfim Milano-Best Vac Pot: No :( Drip: Some $30 thing from Walmart Roaster: I buy pre-roasted.
Posted Sun Jun 2, 2013, 3:58pm Subject: Re: la pavoni europiccola EPBB-8
If you get steam out when the steam valve is open, then the boiler is pressurized. With the handle fully raised, the piston should be at its uppermost position, above the port from the boiler. If the boiler is pressurized, the lever is fully raised and no water is flowing out of the grouphead then the piston isn't clearing the port. If it's hot but not building pressure, there could be a serious leak, you'd probably see the steam.
If the lever is quite loose and moves up and down significantly without actually moving the valve-stem, then either the holes in the lever-arem are worn, the pins through the arm are worn or both. If the valve stem moves securely with the lever, then it is likely that the piston is unscrewing down the bottom end of the stem. You can disassemble the head, secure the piston (And check/replace the seals while in there).
Symbols: = New Posts since your last visit = No New Posts since last visit = Newest post
Forum Rules: No profanity, illegal acts or personal attacks will be tolerated in these discussion boards. No commercial posting of any nature will be tolerated; only private sales by private individuals, in the "Buy and Sell" forum. No cross posting allowed - do not post your topic to more than one forum, nor repost a topic to the same forum. Who Can Read The Forum? Anyone can read posts in these discussion boards. Who Can Post New Topics? Any registered CoffeeGeek member can post new topics. Who Can Post Replies? Any registered CoffeeGeek member can post replies. Can Photos be posted? Anyone can post photos in their new topics or replies. Who can change or delete posts? Any CoffeeGeek member can edit their own posts. Only moderators can delete posts. Probationary Period: If you are a new signup for CoffeeGeek, you cannot promote, endorse, criticise or otherwise post an unsolicited endorsement for any company, product or service in your first five postings.