Posted Tue Mar 5, 2013, 9:23pm Subject: Re: PID Controller Instructions and How To Install PID on Gaggia & Steam
NO CHEMEX FOR ME TOMORROW! HAHA
It seems to be working now. thanks for all your help! All I have left is some window dressing so it's not a hideous mess. Now I want one of those project boxes. basically an additional $30 (including shipping). Click Here (www.auberins.com)
Posted Tue Mar 5, 2013, 9:39pm Subject: Re: PID Controller Instructions and How To Install PID on Gaggia & Steam
In a couple of days you will want to tighten the SSR screws and PID screws. The wires can crush a bit and it is worth a check. I will be interested to hear how it works. You may want to understand the PID controller as you get time to read the manual.
You can raise the P, and I and D to help damp out the PID portion if it oscillated much. I get up about 222F with initial heating and oscillate a little up and down.
Expect a fair amount of oscillation with brew switch and steam. Brew especially as you are getting cold water in so a fair fall as heat goes off.
To get full intrashot help, you need to blip steam for a few seconds prior to pull, so I guess you get to read and understand the thread :)
Posted Tue Mar 5, 2013, 10:01pm Subject: Re: PID Controller Instructions and How To Install PID on Gaggia & Steam
Ill keep learning but Im glad you stuck with me because this was my first PID project.
The only thing i noted now was a hissing sound when I turn the steam on. I'm not sure if this is okay or not. It goes to temperature fine. Could this be cause by inadvertent wire rubbing against the 285 degree boiler? Or maybe the sound of the SSR dissipating heat? it's just weird and I want to figure it out before i put the top on and take it out of mind.
Posted Tue Mar 5, 2013, 10:11pm Subject: Re: PID Controller Instructions and How To Install PID on Gaggia & Steam
Hiss or a slight noise from the controller? You should not have a wire touching the boiler. I used zipties to control the wires. Tie the wires to existing wires, not to metal. Is the noise related to heat or just power on?
I do not leave the steam switch on without opening the steam valve. The heat cycle on and off is higher than before so more pressure. Steam leak through the wand? Steam through the group?
Symbols: = New Posts since your last visit = No New Posts since last visit = Newest post
Forum Rules: No profanity, illegal acts or personal attacks will be tolerated in these discussion boards. No commercial posting of any nature will be tolerated; only private sales by private individuals, in the "Buy and Sell" forum. No SEO style postings will be tolerated. SEO related posts will result in immediate ban from CoffeeGeek. No cross posting allowed - do not post your topic to more than one forum, nor repost a topic to the same forum. Who Can Read The Forum? Anyone can read posts in these discussion boards. Who Can Post New Topics? Any registered CoffeeGeek member can post new topics. Who Can Post Replies? Any registered CoffeeGeek member can post replies. Can Photos be posted? Anyone can post photos in their new topics or replies. Who can change or delete posts? Any CoffeeGeek member can edit their own posts. Only moderators can delete posts. Probationary Period: If you are a new signup for CoffeeGeek, you cannot promote, endorse, criticise or otherwise post an unsolicited endorsement for any company, product or service in your first five postings.